BACK TO HOMEPAGE
Steel Products
Aluminum Products
Fiberglass Products
Cast Iron Products
SEARCH BY APPLICATION
How To Order
Request Information
Welding Glossary
Contact Us |
|
|
|
All gratings are to be firmly anchored to their supports by positive means.
|
1. WELDED ANCHORAGE
Welds at ends of bearing bar apporoximately 6 in. (150 mm) from each side of panel and one weld in the middle of panel at each intermediate support.
Recommended for all permanently installed gratings.
|
|
2. SADDLE CLIPS
Clips are supplied by grating manufacturer. Other fastening accessories can be provided by manufacturer upon request.
Available in steel, stainless steel and aluminum (cross bars may have to be cut during installation).
May be used for installations where grating is subject to removal. Should be in same location as welds in 1. Fasteners are 1/4" (6.4) diameter.
|
|
3. WELDLUGS
Lugs are supplied by grating manufacturer. Other fastening accessories can be provided by manufacturer upon request.
Shop welded to bearing bars - must be specified when ordering.
May be used for installations where grating is subject to removal. Should be in same location as welds in 1. Fasteners are 1/4" (6.4) diameter.
|
|
4. G-CLIPS (No Drilling Required)
Other types of anchors which have been apporopriately tested and have demonstrated satisfactory performance may be used also.
Included in other types are top-mounting mechanical friction anchors which can be installed without requiring access to the underside of the grating and which eliminate field welding and/or drilling. These anchors are removable and may be used where gratings are subject to frequent removal.
|
|
Copyright ©
2003 All American Grating. All rights reserved. Site design by
BDT Custom Computers
Email Address: info@aagrating.com / Phone Number: (800) 962-9692 / Fax Number: (412)
771-6980
Mailing
Address: All American Grating, 3001 Grand Avenue, Pittsburgh, PA 15225
|
